David Clark 9800 Series Manual de instalación descargar pdf (Pagina 9)

9532P-62 (03-11)

of 32

1. Mounting the Master Station

arts/Tools Required

q U

9800S Series 9800 Intercom System Master Station (40898G-01)

q Master Station Mounting Kit (40688G-63)

o 4 neoprene washers

o 4 Stainless steel screws

o 4 Nylon washers

o 4 Stainless steel washers

o 4 Stainless steel nuts

q Pencil/Pen

q Drill

q 7/32-inch Drill Bit

q Drilling Template (Figure 3)

q Philips-head screwdriver

q 11/32-inch nut driver or wrench

Procedure

ocation Considerations

Select a location on a flat surface that is out-of-the-way, and provides adequate room to attach all

cables. Be sure to allow for internal access, as adjustments may be necessary. The Master

Station is weather resistant, however the mounting location should be chosen to minimize direct

exposure to the elements.

Mounting

q Using the mounting template in Figure 3, mark and drill the (4) 7/32-inch holes through the

mounting surface.

q Remove the cover and position the Master Station on the mounting surface and confirm

mounting holes.

q Mount the Master Station using the hardware provided. Slide nylon washer over each screw

before using. Place a neoprene washer between the Master Station and the surface where

each screw is located. Use a stainless-steel washer on the back side of the surface under

each nut. Secure tightly with a stainless-steel lock-nut. See Figure 2.

q The installer may wish to leave the cover removed from the Master Station, as internal

adjustments may be necessary later during the installation. Be sure to replace cover and

tighten the four screws when adjustments are completed.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 42 43

Sin comentarios

David Clark 9800 Series Manual de instalación Pagina 9